Sam Rolfe
611fdf812b
- Reconnect and re-subscribe on every (re)connect; log the subscribe result. - Heartbeat every 5 min on voice/audio_stream (valid silent PCM frame) so the Directive-1 watchdog can tell "device dead" from "nobody spoke". voice_bridge treats it as silence and ignores it. - Retained LWT "offline" / "online" presence on voice/status for layer attribution in the watchdog. - LED: green now means MQTT connected AND publishing. Wi-Fi down = red blink, Wi-Fi up but MQTT down = amber blink. Never green without MQTT. - Log the reason on every drop: PubSubClient state code, or the Wi-Fi disconnect reason from the Wi-Fi event. - Bound the I2S read (50 ms) so Wi-Fi/MQTT housekeeping cannot stall; reset a stale streaming state on disconnect (the stuck-green bug). - Document the MQTT/LED contract in README; flag config.h and led_control.h as stale drafts so they cannot creep back as a second config. - Credentials stay placeholders; nothing secret is committed. Not flashed/tested: no ESP32 and no arduino-cli is reachable from the build environment. Hardware-in-the-loop verification needs a human at the device. Co-Authored-By: Paperclip <noreply@paperclip.ing>
38 lines
1.3 KiB
C
38 lines
1.3 KiB
C
#pragma once
|
|
|
|
// STALE / UNUSED. This file is an early draft and is NOT compiled: the sketch
|
|
// voice_assistant.ino does not include it and holds the live config itself.
|
|
// The values below are wrong for the running device (broker .30 and the
|
|
// homeassistant/voice/* topics belong to an older design). Kept only so old
|
|
// checkouts do not break; do not add a second config here.
|
|
|
|
// --- WiFi ---
|
|
const char* WIFI_SSID = "Aussie Broadband 8729";
|
|
const char* WIFI_PASS = "WIFI_PASS_REDACTED";
|
|
|
|
// --- MQTT ---
|
|
const char* MQTT_BROKER = "192.168.20.30";
|
|
const int MQTT_PORT = 1883;
|
|
const char* MQTT_USER = "MQTT_USER_REDACTED";
|
|
const char* MQTT_PASS = "MQTT_PASS_REDACTED";
|
|
|
|
// --- MQTT Topics ---
|
|
const char* TOPIC_AUDIO = "homeassistant/voice/audio";
|
|
const char* TOPIC_ACK = "homeassistant/voice/ack"; // HA replies here
|
|
|
|
// --- Hardware Pins (ESP32-S3) ---
|
|
// CHECK YOUR BOARD IMAGE FOR THESE PINS
|
|
#define I2S_SD 10 // Serial Data (INMP441 SD)
|
|
#define I2S_WS 11 // Word Select (INMP441 WS/LRCK)
|
|
#define I2S_SCK 12 // Serial Clock (INMP441 SCK/BCLK)
|
|
|
|
// --- LED Ring ---
|
|
#define LED_PIN 48 // CHECK PIN (Often 48 on S3-Zero, or 21, 38, etc)
|
|
#define NUM_LEDS 12
|
|
#define LED_TYPE WS2812B
|
|
#define COLOR_ORDER GRB
|
|
|
|
// --- Audio ---
|
|
#define SAMPLE_RATE 16000
|
|
#define BUFFER_LEN 1024 // Buffer size for MQTT chunks
|